"表1"
,"附表1"
,"2010年广东省皮肤毛发护理器具产品质量专项监督抽查结果汇总表"
"序号","生产企业所在地级市","企 业 及 样 品 情 况",,,,,,"检 验 项 目",,,"综合判定","不合格程度综合判定","获得名牌情况","抽样人员","检验人员","承检机构名称","检验报告编号","备注"
,,"销售企业名称","生产企业名称","产品名称","型号规格","商标","生产日期","不合格项目","标准要求","实测值"
1,"广州市","/","广东康美斯美容用品实业有限公司","焗油机","07A 650W 220V～ 50Hz","CME","2010.07.22","标志和说明","/",,"合格","/","/","乔穗升,张伟清","李海舟","广东产品质量监督检验研究院","2010-A033369-0710-F05"
2,"广州市","/","松下电工·万宝电器(广州)有限公司","电吹风","EH-ND20 1200W 220V～ 50Hz","Panasonic","/","/","/",,"合格","/","/","黄鹏,林建华","黄波涛","广东产品质量监督检验研究院","2010-A058764-0710-F01-C2"
3,"广州市","/","广州市健峰酒店用品有限公司","电吹风","JF404 1000W 220V～ 50Hz","健浩",2010.07,"标志和说明","/",,"合格","/","/","黄鹏,林建华","黄颖姮","广东产品质量监督检验研究院","2010-A060075-0710-F01"
4,"广州市","/","广州市康一明电器有限公司","电吹风","KB-T6 1000W 220V～ 50Hz","康明","2010.07.30",,,,"合格","/","/","乔穗升,张伟清","黄波涛","广东产品质量监督检验研究院","DQ1000647"
5,"广州市","/","松下电工·万宝电器(广州)有限公司","离子蒸汽美容器","EH2424 290W 220V～ 50Hz","Panasonic","/","/","/",,"合格","/","/","黄鹏,林建华","黄波涛","广东产品质量监督检验研究院","2010-A058764-0710-F01-C1"
6,"广州市","/","广州市世纪劲力电器有限公司","电吹风","RCY-9581 850W 220V～ 50Hz ","劲力牌","2010.08.01","1,骚扰电压","1,骚扰电压","1,不符合","不合格","一般不合格","/","乔穗升,陈家荣","黄颖姮","广东产品质量监督检验研究院","DQ1000628"
7,"广州市","/","广州市康一明电器有限公司","电吹风","KB-41S 2000W 220V～ 50Hz","康明","2010.07.26","1,非正常工作; 2,谐波电流.","1.在非正常或误操作情况下应避免引起火灾危险,机械性损坏; 2.谐波电流.","1.不符合/19.2试验期间,器具内部线路短路,但热断路器未动作,器具仅能依靠固定布线的过流保护装置提供保护. 2.不符合.","不合格","严重不合格","/","乔穗升,张伟清","黄颖姮","广东产品质量监督检验研究院","DQ1000646"
8,"广州市","/","广州市白云区艾德森电器厂","电吹风","3808 1800W 220-240V 50Hz","比特","2010.08.03","1,标志和说明; 2,发热; 3,非正常工作; 4,谐波电流; 5,骚扰电压.","1.制造厂或责任承销商的名称,商标或识别标志;为了增加保护,建议在浴室供电电气回路中安装一个额定剩余工作电流不超过30mA的剩余电流装置(RCD);Y型连接的器具,更换软线的说明;IEC60417-1规定的5582符号的外接圆直径应至少为10mm.(GB4706.15); 2.在正常使用中,器具及周围环境温度不应过高; 3.在非正常或误操作情况下应避免引起火灾危险,机械性损坏;试验期间,器具不应喷射出火焰,熔融金属,达到危险量的有毒性或可点燃的气体. 4.谐波电流; 5.骚扰电压.","1.不符合/铭牌上为"艾德森(中国)电器",与证书不符;不符合/无此说明;不符合/无此说明;不合格/外接圆直径为3.4mm; 2.不符合;不符合/内部布的温升为63.8K,超出限定值(55K); 3.不符合/样品在进行19.2试验期间燃烧;不符合/样品在进行19.2试验期间燃烧,无法进行19章其他相关条款的试验; 4.不符合; 5.不符合.","不合格","严重不合格","/","乔穗升,张伟清","黄颖姮","广东产品质量监督检验研究院","DQ1000645"

下一页